LATEST POST

HVAC Simulator – HVAC Training

Continue Reading →

LATEST POST

Coming Soon – HVACTraining.TV

It has been months in development, but we are very close to launching HVACTraining.TV. Throughout the years I have received many requests for stand alone online HVAC training that HVAC contractors can use for group training. While our online courses are designed to help standardize the training of your techs and provide a career path, it…

Continue Reading →

HVAC Simulator – HVAC Training

Continue Reading →

Nitrogen Purging and Brazing

Most HVAC installation instructions require flowing nitrogen through the copper tube during brazing. This is an important step in producing a quality HVAC system. Why nitrogen purge? Oxygen in the air combines with copper to form surface copper oxide. We see this on copper tube as a light to dark brown discoloration. You’ve probably seen ACR/medical gas…

Continue Reading →

Current Relays Commercial Refrigeration

On start-up, the amp draw of the compressor is near LRA before the rotor starts to turn. The high current in the power leg going from M, through R, to the run winding, energizes the relay coil between terminals L and M. The coil pulls in the normally open (NO) contacts L and S. Line voltage…

Continue Reading →

Motor Starters – Video

A motor starter is basically a contactor with overloads . The overloads in the starter are selected according to both the voltage and the RLA of the compressor. These protectors respond to a change in heat caused by voltage drop and amperage increases. If the starter senses an overload condition in any one of the motor…

Continue Reading →

3 Phase Voltage Unbalance

Continue Reading →

Page 1 of 29